Quantum SuperLoader 3 Guida di Avvio Rapido

www.quantum.comSuperLoaderSuperLoader™ 3 Quick Start GuideThe Quantum® SuperLoader 3 is an automated storage and retrieval device consisting of a tape

10 Rack Mounting the AutoloaderSuperLoader 3 Quick Start GuideFigure 5 Sliding Autoloader into Rack5 While the other installer holds the front end of

Autoloader Panel Overviews 11SuperLoaderFigure 7 Connecting Support Brackets7 Verify that the autoloader is level. Adjust as needed.8 When the autolo

12 SCSI Bus RequirementsSuperLoader 3 Quick Start GuideThe Ethernet connector on the back panel allows you to connect to the autoloader remote managem

Connecting SCSI, SAS, or Fibre Channel and Power Cables 13SuperLoaderNote: The maximum number of autoloaders supported per SCSI bus is two. The autol

14 Connecting SCSI, SAS, or Fibre Channel and Power CablesSuperLoader 3 Quick Start GuideFigure 11 Cable Connectors (SAS Tape Drive)Figure 12 Cable

Setting the SCSI ID 15SuperLoaderCaution: Whenever you power cycle the autoloader, allow 10 seconds before turning the power back on. The power supply

16 Preparing the Host and Verifying the ConnectionSuperLoader 3 Quick Start GuidePreparing the Host and Verifying the ConnectionIf necessary, install

Windows Operating System Support 17SuperLoaderNote: Device drivers are required if you intend to use the Microsoft Windows native backup application.

Backup. Recovery. Archive. It’s What We Do.©2012 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, and all other logos are register

2 Choosing a LocationSuperLoader 3 Quick Start Guide Choosing a LocationThe autoloader is designed to fit in a standard 19-inch rack using either the

Preparing for the Installation 3SuperLoader• Preparing for Rack MountingProviding Necessary Tools Provide the following tools for unpacking and instal

4 Unpacking the AutoloaderSuperLoader 3 Quick Start Guide4 Verify that the total current of all rack mounted components (including the autoloader) wil

Unpacking the Autoloader 5SuperLoader5 Remove the foam insert from the magazine bay of the autoloader. Save the packing materials in case you need to

6 Rack Mounting the AutoloaderSuperLoader 3 Quick Start GuideFigure 1 Rack Mount HardwareRack Mounting the AutoloaderThis section provides the steps

Rack Mounting the Autoloader 7SuperLoaderNote: The rails within the rack have a hole pattern that repeats throughout the rail.1 Install two clip nuts,

8 Rack Mounting the AutoloaderSuperLoader 3 Quick Start GuideFigure 3 Attaching Autoloader Brackets3 Using rack screws, attach a support bracket to t

Rack Mounting the Autoloader 9SuperLoaderFigure 4 Attaching Support Brackets4 With the help of a second installer, insert the autoloader into the rac