Quantum Scalar i40 Guida Utente Scaricare il pdf (Pagina 142)

Chapter 5: Performing Library Operations

Releasing Magazines

116 Quantum Scalar i40 and Scalar i80 User’s Guide

Web Client

1 Select Operations > Release Magazine.

2 Select a magazine and press Release.

3 Click OK to confirm.

4 Wait until the Web client displays the Success message, then pull

outward on the magazine bezel handle to slide the magazine out as

far as you wish, or remove it completely. Once you slide the

magazine back into the slot all the way, it locks again automatically.

If you do not open the magazine within 30 seconds, it locks and you

receive a diagnostic ticket.

Releasing Magazines

Manually

Use this method when the library is turned OFF. If you use this method

when the library is turned ON, you will receive a diagnostic ticket.

Caution: If you use the manual method to remove magazine(s)

when the library is turned ON you risk a mechanical

collision between the magazine and the robotics that could

seriously damage components.

1 Insert an opened paperclip, small screwdriver, or other object (3.5

mm or less in diameter that will not break off) into the access hole

in the bottom of the magazine bezel (see

Figure 28).

2 Use the tool to depress the release latch while gently pulling the

magazine bezel handle to slide the magazine out.

3 If the magazine is on the right side, it will only slide out as far as the

I/E station. To release the magazine fully:

• On the Scalar i40 and the bottom right magazine of the Scalar

i80, reach under the open magazine and insert the tool directly

into the access hole in the library chassis to depress the release

latch, while pulling out on the magazine bezel handle.

• On the top right magazine of the Scalar i80, reach under the

open magazine and press the release latch directly with your

finger, while pulling out on the magazine bezel handle.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 327 328

Nessun commento

Quantum Scalar i40 Guida Utente Pagina 142